Upgrading automatically from 3.1 to 4.0 (Windows)

This section describes how to upgrade Kaspersky CyberTrace on Windows.

The instructions below apply to installations done by using the executable installer.

Upgrading from 3.1 to 4.0

To upgrade Kaspersky CyberTrace automatically to a newer version:

Run the executable installer that starts the upgrading process automatically.
At the beginning of the upgrade process, accept the request to stop Feed Service. If you decline to stop it, the upgrade fails.
If Feed Service is stopped and the upgrade continues, all the settings, user accounts data, available feeds, and certificates will be automatically transferred to the new version. If you have a commercial license key, you can add it to Kaspersky CyberTrace on the Licensing tab.

After the upgrade process is finished, the actionable fields are not specified for new feeds that were not supported in the previous version. If needed, specify these fields manually on the Settings > Feeds tab.

Make sure that /opt/kaspersky/ktfs/etc/kl_feed_service.conf contains only a single copy of the FalsePositive and InternalTI suppliers, with corresponding standard names (Black_List.json and White_List.json). If not, the installer displays an error and exits.
Change the settings during the upgrade process, if necessary.
After you finish the upgrade process, Feed Service will be launched automatically.

Note that automatic upgrade with the executable installer is available only if you have accepted the EULA in the installation that is being upgraded.