Enabling and disabling a cellular connection

Kaspersky IoT Secure Gateway 1000 lets you process outgoing and incoming network traffic using a cellular connection (through a cellular communications provider).

To enable or disable the use of a cellular connection on a device running Kaspersky IoT Secure Gateway 1000:

1. In the menu in the left part of the web interface page, select the Network section.
2. Select the WAN tab. In the Modem settings subsection, enable or disable the modem by means of the Use modem as main communication channel toggle switch.
3. Click Save to save the changes made to the settings.

If you are using a cellular connection and network cable is connected to the device WAN connector, and the parameter to automatically obtain external network settings via DHCP is enabled, disconnecting the network cable from the device may cause the default static route to be reset, and traffic will not traverse the device. To restore the default route and allow traffic to traverse the modem, you must reconnect the WAN cable to the device or manually configure a static IP address in the external network settings.

Page top