Adding devices for installing Kaspersky Endpoint Agent for Linux

To install the program remotely using Kaspersky Security Center, you must add the devices that you are installing the program on to the managed devices group.

To add devices for installing the application:

1. Install the Kaspersky Security Center Network Agent on the device.

   The procedure for preparing a Linux-running device for remote installation of Network Agent is described in the Kaspersky Security Center Help.

2. In the command line, run the following command: /opt/kaspersky/klnagent/bin/klmover --address <IP address of the Kaspersky Security Center server>.

   The device becomes available for management using Kaspersky Security Center.

   If Network Agent was previously installed on the device, the first two steps of these instructions are not necessary.

3. Log in to the Kaspersky Security Center Web Console.
4. In the main window of the web console, select Device discovery -> Unassigned devices.

   If Kaspersky Endpoint Security for Linux is installed on a device, the device will reside in the group in which the Kaspersky Endpoint Security for Linux policy is active. You do not need to move the device.

5. In the list of devices, select the check box next to the device where you need to install the application.
6. Click Move to group.
7. This opens a menu on the right side; in the menu, select the check box next to the Managed devices group.
8. Click Move.

The device will become available for remote installation of the application.

Page top