Configuring the maximum size of a scanned file

If you are using the distributed solution and multitenancy mode, use the web interface of the PCN or SCN server for which you want to configure parameters.

To configure the maximum size of a scanned file:

1. Select the Sensor servers section in the window of the application web interface.
2. Click the card of the relevant Sensor component.

   This opens a window with information about the component.

3. Click Edit.
4. Go to the Other tab.
5. Set the Set size limit toggle switch to Enabled.
6. In the Unit of measure field, select a unit of measure.
7. In the Space field, enter the maximum allowed size of a file.
8. Click Save.

The maximum size of a scanned file will be configured.

Configuring the maximum size of a scanned file on a server with the Sensor component installed separately from the Central Node

If you selected network protocols to get mirrored traffic from SPAN ports on a standalone Sensor before connecting it to the Central Node and want to change these settings after connecting, you need to follow the preparatory steps before you change the settings and then follow the instructions above.

Page top