Enabling settings in Kaspersky Endpoint Agent policy

When you configure Kaspersky Endpoint Agent policy settings, by default these settings are saved, but are not applied until you enable them.

You can enable settings for the groups where these settings are located. You can enable either individual groups of settings or all groups of settings within one policy.

To enable the group of settings in Kaspersky Endpoint Agent policy:

1. Open the policy properties window.
   1. In the main Kaspersky Security Center Web Console window select Devices → Policies and profiles.
   2. Select the policy you want to configure.
   3. In the <Policy name> window that opens, select the Application settings tab.
2. Select the section and group of settings to which the required setting belongs.
3. In the upper right corner of the settings group, change the switch from Undefined to Enforce.

All the settings of the group will be applied in the policy after the changes are saved.

If the use of KSN is enabled in the policy and the version of the KSN Statement in the policy differs from the version of the KSN Statement in the Kaspersky Endpoint Agent installed on the host, then after the policy is applied, the use of KSN is disabled on the host and in the policy settings. This situation may occur if Kaspersky Endpoint Agent 3.16 is installed on the host while a lower version of the Kaspersky Endpoint Agent administration plug-in was used to make the last change to the policy.

See also Creating Kaspersky Endpoint Agent policy Configuring KSN usage in Kaspersky Endpoint Agent

Page top