Initial configuration of Network Agent settings

If you plan to manage Kaspersky Endpoint Security via Kaspersky Security Center, you must configure the Network Agent settings.

To configure the Network Agent settings:

  1. Execute the command:
    • for a 32-bit operating system:

      # /opt/kaspersky/klnagent/lib/bin/setup/

    • for a 64-bit operating system:

      # /opt/kaspersky/klnagent64/lib/bin/setup/

  2. Specify the DNS name or IP address of the Administration Server.
  3. Specify the port number of the Administration Server.

    Port 14000 is used by default.

  4. If you want to use an SSL connection, specify the SSL port number of the Administration Server.

    Port 13000 is used by default.

  5. Do one of the following:
    • Enter yes if you want to use an SSL connection.
    • Enter no if you do not want to use an SSL connection.

    By default, SSL connection is enabled.

  6. If necessary, specify the connection gateway mode:
    • 1—Do not configure connection gateway.
    • 2—Do not use connection gateway.
    • 3—Connect to Administration Server through connection gateway.
    • 4—Use this Network Agent as connection gateway.

For more detailed information about configuring Network Agent, please refer to the Kaspersky Security Center documentation.

Page top