Send a synchronization request to the KATA server every (minutes)

Frequency of sending synchronization requests to the KATA server in minutes.

Default value: 5.

Maximum time to wait for the server connection (sec)

Maximum time to wait for a connection to the KATA server in seconds.

The default value is 10.

Maximum time to wait for a response from the server (sec)

Maximum time to wait for a response from the KATA server in seconds.

The default value is 10.

Allow sending telemetry

Enables or disables sending data about events on devices (telemetry) to the KATA server.

Sending telemetry is enabled by default.

Use two-factor authentication

Enables or disables the use of two-way authentication to further secure the connection to the KATA server.

To use two-factor authentication, you need to add a client certificate.

Two-way authentication must be enabled on the KATA server side.

Add (client certificate)

Opens the window for adding a client certificate for additional security of the connection with the KATA server.

The button is displayed if the client certificate has not been added yet.

If you want to configure additional protection for the connection, enable verification of the client certificates on the KATA server side and select the Use two-factor authentication checkbox in this window.

Remove (client certificate)

Removes the client certificate.

The button is displayed if a client certificate has been added.

Add (server certificate)

Opens adding a server certificate window.

The button is displayed if the server certificate has not been added yet.

Remove (server certificate)

Removes the server certificate.

The button is displayed only if a server certificate has been added.