Inventory in the command line

You can use the command line to inventory applications on the protected device as follows:

• With the help of the Inventory_Scan predefined task. You can manually start or stop this task, and configure the task run schedule. You can configure scan settings by editing the settings of this task.
• With the help of user inventory tasks (InventoryScan-type tasks). You can manually start, stop, pause, or resume user tasks and configure the task schedule.

You can view the list of applications detected on the device as a result of the Inventory task by using Application Control management commands.

In this section Inventory task settings Viewing a list of detected applications

Page top