Installing the app in device owner mode

Device owner mode is the device operation mode for company-owned Android devices. This mode allows the administrator to have full control over the entire device and configure a wide range of device functions. Device owner mode is supported on Android 7.0 or later.

To deploy the app in device owner mode, you need to reset the device to factory settings and install the app using the QR code generated in Kaspersky Security Center. The QR code contains all the necessary data for app configuration.

To install the Kaspersky Endpoint Security for Android app on the device in device owner mode:

1. Reset the device to factory settings.

   The device reboots, and the welcome screen appears.

2. Tap six times on an empty space of the device's welcome screen.

   The QR code reader appears.

3. Scan the QR code generated in Kaspersky Security Center for app installation.
4. Perform the initial setup of the device. The operating system installs the Kaspersky Endpoint Security for Android app in the background.

   Once the device setup completes, Kaspersky Endpoint Security for Android starts on the device.

5. Activate the app by following the instructions in the app's Initial Configuration Wizard.

The Kaspersky Endpoint Security for Android app is installed and activated on the device in device owner mode.

Page top