Configuring a Rule Generator for Applications Launch Control task

To configure the Rule Generator for Applications Launch Control task settings:

1. Open the Task settings window of the Rule Generator for Applications Launch Control task.
2. Configure the following settings:
   • On the General tab:
     • Specify Prefix for rule names.
       

       This is the first part of a rule name. The second part of the name of the rule is formed from the name of the object that will be allowed to start.

       The default prefix is the name of the protected device on which Kaspersky Industrial CyberSecurity for Nodes is installed. You can change the prefix for names of allowing rules.

     • Configure the allowing-rules usage scope.
   • On the Actions tab, specify the actions that must be performed by Kaspersky Industrial CyberSecurity for Nodes.
   • On the Schedule and Advanced tabs, configure Schedule task start settings.
   • On the Run as tab, configure Task start settings with account permission.
3. Click OK in the Task settings window.

Kaspersky Industrial CyberSecurity for Nodes immediately applies the new settings to the running task. Information about the date and time when the settings were modified, and the values of task settings before and after modification.

In this section Restricting the task usage scope Actions to perform during automatic rule generation Actions to perform upon completion of automatic rule generation

Page top