Selecting elements in a data table

In a table of a section of the application web interface, you can select any displayed items to view their details and to manage these items. When you select an item in the table, you will see the details area in the right part of the web interface window.

To select the relevant items in the table, do one of the following:

• If you want to select one item, select the check box on the left side of the row containing this item or use your mouse to select the table row.
• If you want to select multiple items, select the check boxes on the left side of the rows containing the relevant items, or select them while holding down the CTRL or SHIFT key.
• If you want to select all items that satisfy the current filter and search settings, do one of the following:
  • Select any item in the table and press the key combination CTRL+A.
  • Select the check box in the title of the left-most column of the table.

When multiple items are selected, the details area may show data on the number of items. The precise number of selected items is displayed up to a specific limit (for example, up to 2,000 items). If more items are selected, the precise number is not displayed (in the above example, 2000+ will be displayed).

The header of the left-most column of the table shows the item selection check box. Depending on the number of selected items, the check box can have one of the following states:

•  – all items that satisfy the current filter and search settings were not selected in the table. In this case, one item or multiple items may be selected in the table by using the check boxes on the left side of rows or by using the CTRL or SHIFT key.
•  – all items that satisfy the current filter and search settings are selected in the table.
•  – all items that satisfy the current filter and search settings were selected in the table, but then the check boxes for some of the items were cleared. This state is also retained if the check boxes were cleared for all items selected in this way (due to the fact that the number of selected items may change).

If all items that satisfy the filter and search settings are selected, the number of selected items may automatically change. For example, this could occur as a result of the user's actions in another connection session or when new items are discovered. You are advised to configure the filter and search settings so that you only see the relevant items in the selection.

Page top