Installation of Network Agent in silent mode (without a response file)

You can install Network Agent with a single .msi package, specifying the values of MSI properties in the standard way. This scenario allows Network Agent to be installed by using group policies. To avoid conflicts between parameters defined through MSI properties and parameters defined in the response file, you can disable the response file by setting the property DONT_USE_ANSWER_FILE=1. An example of a run of the Network Agent installer with an .msi package is as follows.

Installation of Network Agent in non-interactive mode requires acceptance of the terms of the End User License Agreement. Use the EULA=1 parameter only if you have fully read, understand and accept the terms of the End User License Agreement.

Example:

msiexec /i "Kaspersky Network Agent.msi" /qn DONT_USE_ANSWER_FILE=1 SERVERADDRESS=kscserver.mycompany.com EULA=1

You can also define the installation parameters for an .msi package by preparing the response file in advance (one with an .mst extension). This command appears as follows:

Example:

msiexec /i "Kaspersky Network Agent.msi" /qn TRANSFORMS=test.mst;test2.mst

You can specify several response files in a single command.

See also:

Installing Network Agent in non-interactive (silent) mode

Network Agent installation parameters

Ports used by Kaspersky Security Center

General information

Installation in silent mode (with a response file)

Partial installation configuration through setup.exe

Administration Server installation parameters

Page top