Configuring the Anti-Phishing module

To configure the Anti-Phishing module:

1. In the application web interface window, select the Settings → General → Protection section.
2. Select the Anti-Phishing tab.
3. Enable or disable the Anti-Phishing module with the Use Anti-Phishing toggle switch.

   The Anti-Phishing module is enabled by default.

4. If at the previous step you enabled the Anti-Phishing module, in the Maximum scanning time (s) field, enter the maximum duration of an Anti-Phishing scan in seconds.

   Possible values: integers from 1 to 600. Default value: 30.

   If the scan of a message does not finish within the configured time limit, KSMG:

   • Interrupts the message scan.
   • Performs your configured action on the message.
   • Assigns the Error status to the message.
   • Adds an entry to the Syslog Event Log.
5. Click Save.

The Anti-Phishing module is configured.

Page top