Step 2. Routing

This is a required step of the Installation Wizard. We recommend sending events to at least two destinations: to the correlator for analysis and to the storage for storage. You can also select another event router as the destination.

To specify the settings of the destination to which you want the event router to send events received from collectors:

1. In the Routing step of the installation wizard, click Add.
2. This opens the Create destination window; in that window, specify the following settings:
   1. On the Basic settings tab, in the Name field, enter a unique name for the destination. The name must contain 1 to 128 Unicode characters.
   2. You can use the State toggle switch to enable or disable the service as needed.
   3. In the Type drop-down list, select the type of the destination. The following values are available:
      • nats-jetstream
      • tcp
      • http
      • kafka
      • file
      • storage
      • correlator
      • eventRouter
   4. On the Advanced settings tab, specify the values of parameters. The set of parameters that can be configured depends on the type of the destination selected on the Basic settings tab. For detailed information about parameters and their values, click the link for each type of destination in paragraph "c." of these instructions.

The created destination is displayed on the Installation Wizard tab. A destination resource can be removed from the resource set by selecting it and clicking Delete in the opened window.

Routing is configured. You can proceed to the next step of the installation wizard.

Page top