If you are using Debian or Ubuntu in a language other than English, you must change the language of the operating system prior to starting initial configuration of the application.
To start automatic configuration of the application, run the following command:
/opt/kaspersky/kwts/bin/setup.py --auto-install=<full path to the automatic configuration file>
The settings of the automatic configuration file for the application are listed in the table below.
Settings of the automatic configuration file for the application
Parameter |
Description |
Available values |
|---|---|---|
|
Acceptance of the terms of the License agreement. |
|
|
Acceptance of the terms of the Privacy Policy. |
|
|
Consent to set the default protection settings. |
|
|
Selection of the IP address of the network interface used for interaction with other nodes of the cluster. |
|
|
Selection of the port used for interaction with other nodes of the cluster. It is recommended to use the default value of 9045. |
|
|
Entry of the local administrator password. |
< |