Changing variables in the HTTP mode init script

You can configure Kaspersky Scan Engine by changing one or more variables in the init script located at /etc/init.d/kavhttpd.

• SDKPATH—Specifies the directory where Kaspersky Scan Engine is located. The default value is /opt/kaspersky/ScanEngine.
• CONFILE—Specifies the name and the location of the HTTP mode configuration file. The default value is /etc/kavhttpd.xml.
• PIDFILE—Specifies the name and the location of the PID file. The default value is /var/run/kavhttpd.pid.

  The script adds a -p option to the command line when launching the Kaspersky Scan Engine binary file.

• PROGNAME—Specifies the name of the Kaspersky Scan Engine binary file. The default value is kavhttpd.
• USE_WATCHDOG—Specifies whether monitoring is enabled or disabled. The default value is 0 (monitoring is disabled). To enable monitoring, specify 1.

  For more information about monitoring, see section "Monitoring Kaspersky Scan Engine in HTTP mode".

Page top