This section describes how to use the kl_access_util utility. With this utility, you can do the following:
admin
account. After the reset, you can change the password in the Kaspersky Scan Engine GUI.The kl_access_util utility is run from the command line as follows:
./kl_access_util [-r] | [-n
<token-name> -t <token-value>
] | [-v] | [-h]
The table below describes the kl_access_util options.
kl_access_util options
Option |
Description |
---|---|
or
|
Sets the password for the |
or
|
Specifies the name of an API token used for authentication. If the token with the specified name already exists, Kaspersky Scan Engine updates this token (replaces the old value with the new one specified in If the token with the specified name does not exist, Kaspersky Scan Engine creates a new token with the given name and value. Combine this option only with |
or
|
Specifies the value of an API token used for authentication. The value is assigned to the token with the name specified in The value must be unique and contain from 4 to 100 ASCII characters. There must be at least one uppercase Latin letter, one lowercase Latin letter, one digit, and one of the following special characters: When creating or updating a token, the utility encrypts the token value. Combine this option only with |
or
|
Prints the version of Kaspersky Scan Engine to the command line. |
or
|
Prints the Help information about the kl_access_util utility to the command line. |