Since the DMZ host is only for downloading feeds, you can configure the settings below for the previously enabled feeds in CyberTrace on the local host. You can change the following feeds parameters:
confidence
value (except for Kaspersky feeds)You can also disable any feed that had been enabled before (in this case, the disabled feeds will continue to be downloaded on the DMZ host and transferred to the local host, until you disable them in %dmz_fu%/kl_feed_util.conf
).
You can configure the proxy server settings directly in the %dmz_fu%\kl_feed_util.conf
file on the DMZ host.
If necessary, you can add a new feed as described below.
If any feed was previously disabled on the local host, the actions below will stop downloading this feed on the DMZ host.
To add a new feed, do the following:
If custom feeds were previously configured in Kaspersky CyberTrace, also save the httpsrv\etc\custom_feed_list.conf
file for further use.
Run the sc stop cybertrace
command.
If you did not remove CyberTrace on the DMZ host during initial setup, skip this step.
Run the sc stop cybertrace
command.
%service_dir%/bin/.need_run_wizard
file.If you did not remove CyberTrace on the DMZ host during initial setup, skip this step.
%service_dir%\bin\kl_feed_service.conf
and %service_dir%\bin\kl_feed_util.conf
files with the files exported from the local host in Step 1 above.If custom feeds were previously configured in Kaspersky CyberTrace, also replace or add (if the file was not present) the httpsrv\etc\custom_feed_list.conf
file.
Specify the proper Configuration
>GUISettings
>HTTPServer
>ConnectionString
to open CyberTrace Web in a browser.
Run the sc start cybertrace
command.
Configuration/GUISettings/HTTPServer/ConnectionString
of the %service_dir%\bin\kl_feed_service.conf
file.Ensure that the feeds are configured correctly by running a feeds update in CyberTrace at least once.
If custom feeds were previously configured in Kaspersky CyberTrace, also save the httpsrv\etc\custom_feed_list.conf
file for further use.
Settings/Feeds
and Settings/ProxySettings
from the kl_feed_util.conf
exported file to the %dmz_fu%\kl_feed_util.conf
file.Do not remove the instance of the kl_feed_util.conf
file exported from CyberTrace, as well as kl_feed_service.conf
. These files will be used on the local host.
%service_dir%\bin\kl_feed_service.conf
and %service_dir%\bin\kl_feed_util.conf
files with the files exported from the DMZ host.If custom feeds were previously configured in Kaspersky CyberTrace, also replace or add (if the file was not present) the httpsrv\etc\custom_feed_list.conf
file.
Specify the proper Configuration
>GUISettings
>HTTPServer
>ConnectionString
to open CyberTrace Web in a browser.
Run the sc start cybertrace
command.
Configuration
>GUISettings
>HTTPServer
>ConnectionString
, open CyberTrace Web and make sure that the Settings>Feeds page contains the newly added feed and that its settings are similar to the settings on the DMZ host. Also, make sure that all other feeds are configured correctly. Never
in the Update frequency
parameter.