Adding devices for installing Kaspersky Endpoint Agent for Linux

To install the application remotely using Kaspersky Security Center, you must add the devices on which you are installing the application to the managed devices group.

To add devices for installing the application:

1. Install the Kaspersky Security Center Network Agent on the device.

   The procedure for preparing a Linux-running device for remote installation of Network Agent is described in the Kaspersky Security Center Help.

2. In the command line, run the following command: /opt/kaspersky/klnagent/bin/klmover --address <IP address of the Kaspersky Security Center server>.

   The device becomes available for management using Kaspersky Security Center.

   If Network Agent was previously installed on the device, the first two steps of these instructions are not necessary.

3. Open the Kaspersky Security Center Administration Console.
4. In the console tree, select the Managed devices folder.

   If Kaspersky Endpoint Security for Linux is installed on a device, the device is added to the group in which the Kaspersky Endpoint Security for Linux policy is active. You do not need to move the device.

5. In the workspace of the folder, select the Devices tab.
6. Click Move devices to group.

   This opens the move devices wizard.

7. Click Select devices discovered on the network by the Administration Server.
8. In the next window of the wizard, in the list of devices, select the check box next to the device where you need to install the application.
9. Click Next.

   The device is moved to the managed devices group.

10. Click Finish to complete the wizard.

The device becomes available for remote installation of the application.

Page top