Step 7. Configuring a static network route

To configure a static network route:

1. In the IPv4 Routes window, select New and press Enter.

   This opens the IPv4 Static Route window.

2. In the Address/Mask field, enter the IP address and mask of the subnet for which you want to configure the network route.
3. If you want to use the default network route, enter 0.0.0.0/0.
4. In the Gateway field, enter the IP address of the gateway.
5. Select OK and press Enter.
6. If you want to add other network routes, repeat steps 1 through 5 of these instructions for each network route that you want to add.
7. If you are done adding network routes, click Continue.

The configuration may take some time. Then the installation is complete.

See also Step 1. Viewing the End User License Agreement and Privacy Policy Step 2. Selecting a disk for installing the Sandbox component Step 3. Configuring the minimum password length for the Sandbox administrator password Step 4. Creating the Sandbox administrator account Step 5. Configuring the management network interface Step 6. Assigning a hostname and adding DNS server addresses

Page top