Creating a Rule Generator for Applications Launch Control task

To create and configure the Rule Generator for Applications Launch Control task settings:

1. Open the Settings window in the New Task Wizard.
2. Configure the following:
   • Specify Prefix for rule names.
     

     This is the first part of a rule name. The second part of the name of the rule is formed from the name of the object that will be allowed to start.

     The default prefix is the name of the protected device on which Kaspersky Embedded Systems Security is installed. You can change the prefix for names of allowing rules.

   • Configure the allowing-rules usage scope.
3. Click Next.
4. Specify the actions that must be performed by Kaspersky Embedded Systems Security:
   • When generating allowing rules.
   • Upon task completion.
5. In the Schedule window, set the scheduled task start settings.
6. Click Next.
7. In the Selecting an account to run the task window, specify the account you want to use.
8. Click Next.
9. Specify a task name.
10. Click Next.

    The task name should be no longer than 100 characters and cannot contain the following symbols: " * < > & \ : |

    The Finish creating the task window opens.

11. You can optionally run the task after the Wizard finishes by selecting the Run task after Wizard finishes check box.
12. Click Finish to finish creating the task.

To configure an existing rule in Kaspersky Security Center,

open the Properties: Rule Generator for Applications Launch Control window and adjust the settings described above.

Information about the date and time when the settings were modified, and the values of task settings before and after modification, are saved in the system audit log.

In this section Restricting the task usage scope Actions to perform during automatic rule generation Actions to perform upon completion of automatic rule generation

Page top