Preparing for local installation of the Server or a sensor
On the computer where the Server or sensor will be installed, verify that the following conditions are fulfilled:
There is network access to the computer.
The computer has a user account with root privileges (the local installation script will be run under this user account).
The computer does not have any user accounts or groups with the following names that are reserved for interaction between application components (if these accounts exist, they could receive elevated access rights, even root privileges, after the application is installed):
If the Server will be installed:
kics4net
kics4net-apm
kics4net-asset-config-repo
kics4net-asset-inventory
kics4net-blob-storage
kics4net-config-control-orchestrator
kics4net-connectors
kics4net-connectors-launcher
kics4net-email-gateway
kics4net-epp-proxy
kics4net-fts
kics4net-nats-server
kics4net-oval-facade
kics4net-postgresql
kics4net-report-builder
kics4net-report-data-source
kics4net-report-renderer
kics4net-report-tc
kics4net-report-tcv
kics4net-responses-manager
kics4net-risk-oval-detector
kics4net-scap-manager
kics4net-scap-manager-view
kics4net-scan-oval-manager
kics4net-scheduler
kics4net-secrets
kics4net-task-m
kics4net-task-mv
kics4net-vault
kics4net-webserver
If a sensor will be installed:
kics4net
kics4net-apm
kics4net-connectors
kics4net-connectors-launcher
kics4net-epp-proxy
kics4net-nats-server
kics4net-oval-facade
kics4net-websensor
To prepare the computer for the local installation of the Server or a sensor:
Find out and save the following information about the computer:
User account credentials for the account with root privileges that will be used to run the local installation script.
Name and IP address of the computer (for subsequent connection to this computer).
To display the computer name, you can enter the hostname command in the command line. To display information about IP addresses and network interfaces, you can enter the sudo ifconfig command in the command line.
Copy the kics4net-release_<application version>.tar.gz archive from the distribution kit to the computer.
Go to the folder containing the copied archive and enter the following command to unpack it:
tar -zxvf kics4net-release_<application version>.tar.gz
The unpacked folders and files will appear in the subfolder kics4net-release_<application version>.