Adding IP ranges to the list of ranges polled by a distribution point
You can add an IP range to the list of ranges polled by a distribution point.
To add an IP range to the list of polled ranges:
- In the console tree, select the Administration Server node.
- In the context menu of the node, select Properties.
- In the Administration Server properties window that opens, select the Distribution points section.
- In the list, select the necessary distribution point, and then click Properties.
- In the distribution point properties window that opens, in the left Sections pane, select Device discovery → IP ranges.
- Select the Enable range polling check box.
- Click the Add button.
The Add button is active only if you select the Enable range polling check box.
The IP range window opens.
- In the IP range window, enter the name of the new IP range (the default name is New range).
- Click the Add button.
- Do one of the following:
- Specify the IP range using the start and end IP addresses.
- Specify the IP range using the address and subnet mask.
- Click Browse and add a subnet from the global list of subnets.
- Click OK.
- Click OK to add the new range with the specified name.
The new range will appear in the list of polled ranges.
Page top