Deployment by capturing and copying the image of a device
If you need to install Network Agent on devices on which an operating system and other software also must be installed (or reinstalled), you can use the mechanism of capturing and copying the image of that device.
To perform deployment by capturing and copying a hard drive:
Create a reference device with an operating system and the relevant software installed, including Network Agent and a security application.
Capture the reference image on the device and distribute that image on new devices through the dedicated task of Kaspersky Security Center Linux.
To capture and install disk images, use third-party tools available in the organization.
Copying a disk image with third-party tools
When applying third-party tools for capturing the image of a device with Network Agent installed, use one of the following methods:
On the reference device, stop the Network Agent service and run the klmover utility with the -dupfix key. The utility klmover is included in the installation package of Network Agent. Avoid any subsequent runs of Network Agent service until the image capturing operation completes.
Make sure that klmover will be run with the -dupfix key before (mandatory requirement) the first run of the Network Agent service on target devices, at the first launch of the operating system after the image deployment. The utility klmover is included in the installation package of Network Agent.
If the hard drive image has been copied incorrectly, you can resolve this problem.
You can also capture the image of a device without Network Agent installed. To do this, perform image deployment on target devices and then deploy Network Agent. If using this method, provide access to the network folder with stand-alone installation packages from a device.