Automatically created agents have the following special conditions:
Automatically created agents can have only one connection.
Automatically created agents are displayed under Resources → Agents, and auto created is indicated at the end of their name. Agents can be reviewed or deleted.
The settings of automatically created agents are defined automatically based on the collector settings from the Connect event sources and Transport sections. You can change the settings only for a collector that has a created agent.
The description of an automatically created agent is taken from the collector description in the Connect event sources section.
Debugging of an automatically created agent is enabled and disabled in the Connect event sources section of the collector.
When deleting a collector with an automatically created agent, you will be prompted to choose whether to delete the collector together with the agent or to just delete the collector. When deleting only the collector, the agent will become available for editing.
When deleting automatically created agents, the type of collector changes to http, and the connection address is deleted from the URL field of the collector.
If at least one Windows log name in wec or wmi connector is specified incorrectly, the agent will not receive events from any Windows log listed in the connector. At the same time the agent status will be green. Attempts to receive events will be repeated every 60 seconds, and error messages will be added to the service log.
In the KUMA interface, automatically created agents appear at the same time when the collector is created. However, they must still be installed on the asset that will be used to forward a message.