Viewing incidents

To view incidents that were registered on a specific date:

1. In the main menu, select the Incidents section.
2. In the upper part of the opened page, on the bar graph, click the graph column for the relevant date.
3. If necessary, filter incidents by detector, top tag, status, group, or incident cause by selecting relevant values in the corresponding drop-down list.

The table located in the central area of the page shows the incidents registered on that day according to the specified filtering criteria. When you click the Reset button, the table and the bar graph show all registered incidents.

The following information is displayed for each incident in the table:

• ID refers to the ID of the registered incident.
• Date and time refers to the date and time when the incident was registered.

  Clicking the incident registration date opens the History section, where you can view information about the "Tags for event #N" preset generated for the registered incident.

• Top tag name refers to the name of the process parameter for which the largest deviation from the prediction was recorded at the time of incident registration.
• Incident cause refers to the cause of the registered incident added by an expert (process engineer or ICS specialist) based on the results of the incident analysis.
• Detector refers to the name of the detector that identified an anomaly and registered the incident: Forecaster, Limit Detector, XGBoost, Rule Detector, Stream Processor.
• Group refers to the name of the incident group to which the registered incident belongs.

  If two or more similar incidents are detected, they are combined into a group that is created automatically by using the Similar Anomaly component. You can view only those incidents included in the group by selecting the group name from the drop-down list.

• Status refers to the status of a registered incident specified by an expert (process engineer or ICS specialist) based on the results of the incident analysis.

  You can set the incident status based on analysis results by selecting the appropriate value from the drop-down list. After installation of Kaspersky MLAD, the following statuses of incidents and incident groups are available by default: Under review, Decision pending, Instructions issued, Problem closed, Cause unknown, Ignore and False positive. If necessary, a user with administrator privileges can create, edit, or delete the statuses of incidents.

Page top