Adding a static route

In addition to dynamic route exchange between CPE devices and external network devices via BGP and OSPF protocols, Kaspersky SD-WAN supports static IPv4 routes. You can add a static route in a CPE template or on a CPE device. A static route added to the CPE template is automatically added to all CPE devices that use this CPE template.

To add a static route:

  1. Add a static route in one of the following ways:
    • If you want to add a static route in a CPE template, go to the SD-WAN → CPE templates menu section, click the CPE template, and select the Static routes tab.
    • If you want to add a static route on a CPE device, go to the SD-WAN → CPE menu section, click the CPE device, and select the Static routes tab and select the Override check box.

    A table of static routes is displayed.

  2. Click the add static route icon plus button.
  3. In the Interface drop-down list, select the created source network interface of the static route.
  4. In the Target field, enter the destination IPv4 address of the static route.
  5. If necessary, in the IPv4 netmask field, enter the IPv4 address of the destination subnet of the static route.
  6. In the Gateway field, enter the IP address of the gateway of the static route.
  7. In the Metric field, enter a metric for the static route. The default setting is 0.
  8. In the MTU field, enter the MTU value for the static route.
  9. In the Type drop-down list, select the type of the static route:
    • unicast (default)
    • local
    • broadcast
    • multicast
    • unreachable
    • prohibit
    • blackhole
    • anycast
  10. If you want to add a static route in a virtual routing and forwarding table, in the VRF drop-down list, select a created virtual routing and forwarding table. You must add the static route to the virtual routing table that contains the network interface of the source of the static route.

    The static route is added and displayed in the table. You can add multiple static routes or delete a static route. To delete a static route, click the delete icon minus button next to it.

  11. In the upper part of the settings area, click Save to save the settings of the CPE template or CPE device.
Page top