Specifying the address of a CPE device

To specify the address of a CPE device:

  1. In the menu, go to the SD-WAN → CPE section.

    A table of CPE devices is displayed.

  2. Click the CPE device whose address you want to specify.

    The settings area is displayed in the lower part of the page. You can expand the settings area to fill the entire page by clicking the expand icon expand_panel_up_icon_2. By default, the Configuration tab is selected, which displays general information about the CPE device. This tab also displays the table of Out-of-band management tasks being performed by the orchestrator.

  3. In the upper part of the settings area, under Actions, click Set location.
  4. This opens a window; in that window, enter the address of the CPE device's location. As you enter the address, you are prompted to select an address from a drop-down list.

    The address is displayed on the map.

  5. Click Save.

The address of the CPE device is specified.

Page top