Enabling and disabling a CPE device

When a CPE device is enabled, a CPE template is applied to it. Disabled CPE devices cannot be used to relay traffic.

To enable or disable a CPE device:

1. In the menu, go to the SD-WAN → CPE section.

   A table of CPE devices is displayed.

2. Click the CPE device that you want to enable or disable.

   The settings area is displayed in the lower part of the page. You can expand the settings area to fill the entire page by clicking the expand icon . By default, the Configuration tab is selected, which displays general information about the CPE device. This tab also displays the table of Out-of-band management tasks being performed by the orchestrator.

3. In the upper part of the settings area, under Actions, click Enable or Disable.

The CPE device is enabled or disabled.

See also Scenario: Automatic registration (ZTP) of a CPE device Scenario: Re-registering a CPE device

Page top