Shutting down a CPE device

You can power off the CPE device in the orchestrator web interface, or by disconnecting the power cable from the CPE device. When the power is turned off in the orchestrator web interface, the shutdown command is sent to the operating system of the CPE device.

To power off the CPE device in the orchestrator web interface:

  1. In the menu, go to the SD-WAN → CPE section.

    A table of CPE devices is displayed.

  2. Click the CPE device that you want to shut down.

    The settings area is displayed in the lower part of the page. You can expand the settings area to fill the entire page by clicking the expand icon expand_panel_up_icon_2. By default, the Configuration tab is selected, which displays general information about the CPE device. This tab also displays the table of Out-of-band management tasks being performed by the orchestrator.

  3. In the upper part of the settings area, under Actions, click Shutdown.
  4. In the confirmation window, click Shutdown.

The CPE device is shut down.

Page top