Managing controllers

To display the table of controllers, go to the Infrastructure menu section, click the created data center, and select the Network resources tab. Information about controllers is displayed in the following columns of the table:

• Name is the name of the controller.
• Transport/service strategy is the transport strategy being used.

  A transport service encapsulation mechanism that includes the algorithm for adding a stack of traffic packet header tags and the type of these tags. Kaspersky SD-WAN temporarily supports one transport strategy, Generic VNI Swapping Transport.

• Controller nodes are IP addresses of controller nodes.
• Connection type is the type of connection of CPE devices to the controller:
  • Unicast
  • Multicast
• Cluster status is the status of the cluster of controller nodes:
  • Up means the cluster is operating normally.
  • Degraded means an error occurred during the operation of the cluster.
  • Down means the cluster is not operational.
• Node statuses is the status of controller nodes:
  • Connected (primary) means the node is connected to the controller and is the primary node in the cluster.
  • Connected (single) means the node is connected to the controller and is the only node in the cluster.
  • Connected (secondary) means the node is connected to the controller and is a secondary node in the cluster.
  • Disconnected means the node is not connected to the controller.
  • Not in cluster means the node is not added to a cluster.
  • Unavailable means the node is not available.
  • Unknown means the status of the node is unknown.

The actions you can perform with the table are described in the Managing solution component tables instructions.

In this section Editing a controller Reprovisioning a controller Restoring controller settings Enabling or disabling the maintenance mode on a controller Deleting a controller Managing controller properties Viewing information about controller nodes

Page top