Installation in interactive mode

To install the Kaspersky Security administration plug-in for tenants in interactive mode using the Wizard:

1. On the computer where the Kaspersky Security Center Administration Console is installed, start the file named ksv-t-components_6.1.0.XXX_mlg.exe. (6.1.0.XXX represents the application version number). This file is included in the distribution kit.

   The Installation Wizard starts for the Kaspersky Security administration plug-in for tenants.

2. Select the localization language of the Wizard and the Kaspersky Security administration plug-in for tenants and proceed to the next step of the Wizard.

   By default, the window uses the localization language of the operating system installed on the computer where the Wizard was started.

3. Read the End User License Agreement concluded between you and Kaspersky, and the Privacy Policy describing the handling and transmission of data.

   To continue the installation, you must confirm that you have fully read and accept the terms of the End User License Agreement and the Privacy Policy. To confirm, select both check boxes in the window of the Wizard.

   Proceed to the next step of the wizard.

4. Review the information about the actions that the Wizard will perform and click Next to begin performing the listed actions.
5. Wait for the wizard to finish.

   If an error occurs during wizard operation, the wizard rolls back the changes made.

6. Click Finish to close the Wizard window.

Information about the work of the Wizard is written to Kaspersky Security administration plug-in for tenants Installation Wizard trace files. If the Wizard ended with an error, you can use these files when contacting Technical Support.

Page top