Canceling the application of network interface settings to a CPE device

If you do not want to apply network interface settings to a CPE device:

1. In the menu, go to the SD-WAN → CPE section.

   A table of CPE devices is displayed.

2. Click the CPE device to which you do not want to apply network interface settings.

   The settings area is displayed. You can expand the settings area to fill the entire page by clicking the expand icon . By default, in the menu on the left, the Configuration section is selected, which displays general information about the CPE device. This section also displays the table of Out-of-band management tasks being performed by the orchestrator.

3. Select the Network tab.

   The table of network interfaces is displayed.

4. Select the Ignore network settings check box. This check box is cleared by default.
5. In the upper part of the settings area, click Save to save CPE device settings.

Network interface settings are not applied to the CPE device.

If you want to apply network interface settings to the CPE device, clear the Ignore network settings check box.

Page top