Enabling interactive mode

You can specify the following interactive mode settings when configuring the connection of a CPE device to the orchestrator and controller:

• The period to wait until the CPE device sends another REST API request to the orchestrator in interactive mode
• The time after which the interactive mode is automatically disabled

To enable interactive mode:

1. In the menu, go to the SD-WAN → CPE section.

   A table of CPE devices is displayed.

2. Click the CPE device on which you want to enable interactive mode.

   The settings area is displayed. You can expand the settings area to fill the entire page by clicking the expand icon . By default, in the menu on the left, the Configuration section is selected, which displays general information about the CPE device. This section also displays the table of Out-of-band management tasks being performed by the orchestrator.

3. In the upper part of the settings area, click Interactive mode.

Interactive mode is enabled on the CPE device.

Page top