You can view the table of IP rules in a CPE template and on a CPE device:
To view the table of IP rules in a CPE template, go to the SD-WAN → CPE templates menu section, click the CPE template, and in the sidebar, select the PBR section.
To view the table of IP rules on a CPE device, go to the SD-WAN → CPE menu section, click the CPE device, and in the sidebar, select the PBR section.
Information about IP rules is displayed in the following columns of the table:
Priority is the rule priority Rules with a lower priority value are applied earlier.
Status is the status of the rule. Possible values:
On means the rule is active.
Off means the rule is inactive.
IP protocol is the IP protocol. The following values are possible:
TCP
UDP
ICMP
SCTP
AH
ESP
GRE
IPIP
Source network interface is the inbound interface to be matched. If the interface is a loopback interface, the rule matches only packets originating from this host.
Source port is the source port.
Source host or network is the source host or network.
Destination network interface is the outbound interface to be matched. The outbound interface is available only for packets originating from local sockets bound to the device.
Destination port is the destination port.
Destination host or network is the destination host or network.
VRF is the VRF in which the search for routes is performed.
Actions lists actions that can be performed with the IP rule (enable, disable, edit, delete).