Send a synchronization request to the KATA/NDR server every (min)

Frequency of sending synchronization requests to the KATA/NDR server in minutes.

The default value is 5.

Maximum time to wait for the server connection (sec)

Maximum time to wait for a connection to the KATA/NDR server in seconds.

The default value is 10.

Maximum time to wait for a response from the server (sec)

Maximum time to wait for a response from the KATA/NDR server in seconds.

The default value is 10.

Allow sending telemetry

This check box enables or disables sending data about events on devices (telemetry) to the KATA server.

Sending telemetry is enabled by default.

The check box is displayed only when integrating with Kaspersky Endpoint Detection and Response (KATA).

Server certificate

The section contains buttons for adding or removing a server certificate.

Add (server certificate)

Opens adding a server certificate window.

The button is displayed if the server certificate has not been added yet.

Remove (server certificate)

Deletes the server certificate added previously.

The button is displayed only if a server certificate has been added.

Additional connection protection

This section contains controls for configuring additional security of the connection using two-way authentication.

Use two-way authentication

This check box enables or disables two-way authentication to further secure the connection to the KATA/NDR server.

To use two-way authentication, you need to add a client certificate.

Two-way authentication must be enabled on the KATA/NDR server side.

Add (client certificate)

Opens the window for adding a client certificate for additional security of the connection with the KATA/NDR server.

The button is displayed if the Use two-way authentication check box is selected and the client certificate has not yet been added.

If you want to configure additional protection for the connection, enable verification of the client certificates on the KATA/NDR server side and select the Use two-way authentication check box in this window.

Remove (client certificate)

Removes the client certificate.

The button is displayed if a client certificate has been added.