Configuring application tracing and memory dump recording
To configure application tracing and memory dump recording:
Open the Compact Diagnostic Interface in one of the following ways:
Run the avpui.exe file in the application installation folder on the protected device. By default, the file is located in C:\Program Files (x86)\Kaspersky Lab\Kaspersky Industrial CyberSecurity for Nodes.4.5.0.
Click the application icon in the taskbar notification area.
Go to the Malfunction diagnosis section.
Use the Write debug information to trace file check box to enable or disable tracing of application operation.
If necessary, click the Browse button to specify the folder where Kaspersky Industrial CyberSecurity for Nodes will save trace files.
The folder must be created in advance and be writable by the SYSTEM account. You cannot specify a network folder, drive, or environment variables.
In the Level of details drop-down list, select the level of detail of the debug information.
Critical means the trace file saves only messages about fatal errors.
Diagnostic means the trace file saves messages about all errors as well as warnings.
Important means the trace file saves messages about all errors, warnings, and additional information.
Normal means the trace file saves messages about all errors, warnings, as well as information about normal operation of the application (default).
Detailed means the trace file saves all information about the operation of the application.
A Technical Support representative determines the detail level required to resolve any potential issues.
The default level of detail is set to Normal.
Specify the Maximum size of a trace file (MB).
Available values: from 1 to 4095 MB. By default, the maximum size of trace files is 100 MB.
To delete the old trace files when the maximum number of files is reached, select the Remove the oldest trace files check box.
Specify the Maximum number of trace files.
Available values: from 1 to 999. By default, the maximum number of files is 5. The field is available if the Remove the oldest trace files check box is selected.
If necessary, configure memory dumps:
Select or clear the Create a dump file on malfunction to the folder check box to enable or disable memory dumping in case of malfunctions.
If necessary, click the Browse button to specify the folder where Kaspersky Industrial CyberSecurity for Nodes will save memory dump files. By default, memory dump files are stored in the following folder: %ProgramData%\Kaspersky Lab\KICS.4.5\Traces.
The folder must be created in advance and be writable by the SYSTEM account. You cannot specify a network folder, drive, or environment variables.