Kaspersky Security Center Linux failover cluster. Hardware and software requirements

To deploy a Kaspersky Security Center Linux failover cluster, you must have the following hardware:

• Two devices with identical hardware and software. These devices will act as the active and passive nodes.

  Configuration of devices that will act as the active and passive nodes

  Hardware	Value
  CPU	16 cores, 2500 MHz
  RAM	32 GB
  Disk space	500 GB, 300 IOPS or higher
  Network interface controller	1 Gbps

• A file server that supports the CIFS/SMB protocol, version 2.0 or later. You must provide a dedicated device that will act as a file server.

  Configuration of a file server

  Hardware	Value
  CPU	16 cores, 2500 MHz
  RAM	32 GB
  Disk space	500 GB, 500 IOPS or higher
  Network interface controller	10 Gbps

  Make sure you have provided high network bandwidth between the file server, and the active and passive nodes.

• A device with Database Management System (DBMS). If you use MariaDB Galera Cluster as a DBMS, a dedicated device for this purpose is not required.

Page top