Configuring the task operation mode

To configure the task operation mode:

1. Open the Traffic Security window.
2. On the General tab, select one of the available modes from the Task mode drop-down list:
   • Driver Interceptor
   • Redirector
   • External Proxy
3. Specify the ICAP service connection settings (required for all three modes):
   • Network port number
     

     The port number of the ICAP service for Kaspersky Security for Windows Server.

   • Service ID
     

     An ID that makes part of the RESPMOD URI parameter of ICAP (see document RFC 3507). RESPMOD URI designates the address of an anti-virus ICAP server installed for the network storage area.

     For example, if the IP address of the protected device is 192.168.10.10, the port number is 1345, and the ICAP service ID is webscan, the corresponding RESPMOD URI address is icap://192.168.10.10/webscan:1345

   Restart the task to apply ICAP service connection settings.

4. Configure the selected task mode.

   No additional configuration is required for the External Proxy mode. Configuration is performed on the external proxy server.

5. Click OK.

The configuration is saved.

Page top