Configuring the application manually

Before starting the initial configuration of the application, make sure that the en_US-UTF-8 locale is installed in the operating system.

To manually configure the application:

1. Run the application configuration script. To do so, execute the command:

   /opt/kaspersky/kwts/bin/setup.py --install

2. Select the language for viewing the End User License Agreement and Privacy Policy. To do so, type the number displayed next to the language that you want to select, and press ENTER.
3. Please express your acceptance or rejection of the End User License Agreement. To do so:
   1. Press ENTER to read the text of the End User License Agreement.
   2. Press the q key to exit the viewing mode.
   3. Do one of the following:
      • If you want to accept the terms of the End User License Agreement, type yes.
      • If you want to reject the terms of the End User License Agreement, type no.
   4. Press ENTER.

   If you reject the terms and conditions of the End User License Agreement, application configuration is not performed.

   You can review the text of the End User License Agreement in a file at any time. The file with the text of the End User License Agreement is located at the following path: /opt/kaspersky/kwts/share/htdocs/<language code>/eula.

4. Please express your acceptance or rejection of the Privacy Policy. To do so:
   1. Press ENTER to read the text of the Privacy Policy.
   2. Press the q key to exit the viewing mode.
   3. Do one of the following:
      • If you want to accept the terms of the Privacy Policy, type yes.
      • If you want to reject the terms of the Privacy Policy, type no.
   4. Press ENTER.

   If you reject the terms and conditions of the Privacy Policy, application configuration is not performed.

5. Please express your acceptance or rejection of the default values for the protection settings. To do so:
   1. Press ENTER to read a description of the default protection settings.
   2. Press the q key to exit the viewing mode.
   3. Do one of the following:
      • If you want to accept the default protection settings, type yes.
      • If you want to reject the default protection settings, type no.
   4. Press ENTER.

   If you do not agree with default protection settings, application configuration cannot be performed.

   After installation, you can change these settings in the Rules section of the application web interface.

6. Type the IP address of the network interface used for interaction with other nodes of the cluster and press ENTER.

   The current active IP address is used by default.

7. Specify the port used for interaction with other nodes of the cluster and press ENTER.

   It is recommended to use the default value of 9045.

8. Set the local administrator password.

   The password must contain:

   • At least 15 characters
   • Only ASCII characters (A-Z, a-z), numerals, and special characters
   • The following types of characters:
     • Uppercase character (A-Z).
     • Lowercase character (a-z).
     • Number.
     • Special character

   You can change the local administrator password in the Local administrator section of the web interface after the application is installed.

The application is configured. After this, you need to add the server to the cluster to manage application settings using the web interface.

Page top