Installing the Sandbox component

This section provides step-by-step instructions on installing the Sandbox component.

Before installing the component, you need to enable nested virtualization support for the virtual machine on which you want to install it. Otherwise, the installation will finish with an error.

To start installing the Sandbox component:

Run the disk image containing the Sandbox component.
The Setup Wizard starts.
Select Continue and press ENTER.

The installation is started.

If nested virtualization is disabled for the virtual machine on which you are installing the component, an error is displayed after starting the installation.

To resolve the error:

Power off the virtual machine on which you are installing the component.
Enable nested virtualization support for this virtual machine.
Power on the virtual machine.
Start the installation of the component by following the instructions above.

The error is resolved.

Watch a video tutorial on deploying the Sandbox component. You can play the video on the Help page (see below) or follow the link https://youtu.be/bx1sbR6vJBw?si=D1PrZ5o4vwIxaNoP.

Deploying the Sandbox component

In this section

Step 1. Viewing the End User License Agreement and Privacy Policy

Step 2. Selecting a disk for installing the Sandbox component

Step 3. Configuring the minimum password length for the Sandbox administrator password

Step 4. Creating the Sandbox administrator account

Step 5. Configuring the management network interface

Step 6. Assigning a hostname and adding DNS server addresses

Step 7. Configuring a static network route