Configuring exclusions from network isolation

Exclusions specified in the policy properties are applied only if network isolation is automatically enabled by the application in response to detection. Exclusions specified in the device properties are applied only if network isolation is enabled manually.

The active policy does not block the usage of network isolation exclusions specified in the device properties, since the scenarios for applying these settings are different.

To configure the settings of network isolation exclusions:

  1. Do one of the following:
    • Open the application properties window for an individual device.
    • Open the policy properties window.
  2. If you open the application properties window for an individual device, in the Network Isolation section, select Exclusions.
  3. If you open the application policy properties window, in the Network Isolation section, select Isolation on detection.

    You can perform the following actions:

    • Add custom exclusion
    • Add exclusions from the list of predefined network profiles
    • Change the settings of the added exclusion
    • Remove exclusion from the list
  4. Click OK to save the changes.

See also

Enabling and disabling network isolation

Enabling and disabling user notification about network isolation

Configuring automatic disabling of network isolation

Page top