Installation and initial configuration of the application

Before starting the installation of Kaspersky Industrial CyberSecurity for Linux Nodes, you must prepare to install the application.

The following scenario describes how to install and perform initial configuration of Kaspersky Industrial CyberSecurity for Linux Nodes, how to install and configure Kaspersky Security Center Network Agent, and how to install Kaspersky Industrial CyberSecurity for Linux Nodes administration plug-ins.

The application installation procedure involves the following steps:

1. Installation and post-installation configuration of the Network Agent

   If you plan to manage Kaspersky Industrial CyberSecurity for Linux Nodes using Kaspersky Security Center, install and configure the Kaspersky Security Center Network Agent on the protected device.

2. Installing the administration plug-in for Kaspersky Industrial CyberSecurity for Linux Nodes

   If you plan to manage Kaspersky Industrial CyberSecurity for Linux Nodes application Kaspersky Security Center, install the Kaspersky Industrial CyberSecurity for Linux Nodes administration plug-in. Depending on the console used to manage Kaspersky Security Center, the following management plug-ins can be used:

   • The Kaspersky Industrial CyberSecurity for Linux Nodes administration web plug-in allows you to manage the application using the Kaspersky Security Center Web Console. The web plug-in is installed on the device that has the Kaspersky Security Center Web Console installed.
   • The Kaspersky Industrial CyberSecurity for Linux Nodes MMC administration plug-in allows you to manage the application using the Kaspersky Security Center Administration Console. The MMC plug-in is installed on the device where Kaspersky Security Center Administration Console is installed.
3. Installing application packages and graphical user interface

   Kaspersky Industrial CyberSecurity for Linux Nodes is distributed as DEB and RPM packages. The application and its graphical interface are supplied as different packages. Install Kaspersky Industrial CyberSecurity for Linux Nodes and the graphical interface, if necessary, from packages in the appropriate format.

   You can perform installation in one of the following ways:

   • Using Kaspersky Security Center.
   • Using the command line.
4. Completing initial setup of Kaspersky Industrial CyberSecurity for Linux Nodes

   The application needs initial configuration to prepare it for operation and enable the protection of the client device.

   If you installed Kaspersky Industrial CyberSecurity for Linux Nodes using Kaspersky Security Center, the initial configuration was performed automatically during installation in accordance with the parameters specified in the installation package. After completing the installation, go through the Getting started procedure.

   If you installed Kaspersky Industrial CyberSecurity for Linux Nodes using the command line, after completing the installation, run the Initial Configuration Wizard and perform the initial configuration interactively or automatically.

   If initial configuration of the application has not been completed on a device, you cannot use or update the application on that device.

In this Help section The installation and initial configuration of Kaspersky Security Center Network Agent Installing the administration plug-ins for Kaspersky Industrial CyberSecurity for Linux Nodes Installing and initially configuring the application using Kaspersky Security Center Installing and initially configuring the application using the command line Configuring allowing rules in the SELinux system Running the application on Astra Linux OS in closed software environment mode Installing or removing the application on a device with the TeNIX WS operating system

Page top