Configuring the Anti-Phishing module
Configuring the Anti-Phishing module
July 3, 2024
ID 203860
To configure the Anti-Phishing module:
- In the application web interface window, select the Settings → General → Protection section.
- Select the Anti-Phishing tab.
- Enable or disable the Anti-Phishing module with the Use Anti-Phishing toggle switch.
The Anti-Phishing module is enabled by default.
- If at the previous step you enabled the Anti-Phishing module, in the Maximum scanning time (s) field, enter the maximum duration of an Anti-Phishing scan in seconds.
Possible values: integers from 1 to 600. Default value: 30.
If the scan of a message does not finish within the configured time limit, KSMG:
- Interrupts the message scan.
- Performs your configured action on the message.
- Assigns the Error status to the message.
- Adds an entry to the Syslog Event Log.
- Click Save.
The Anti-Phishing module is configured.
Did you find this article helpful?
What can we do better?
Thank you for your feedback! You're helping us improve.
Thank you for your feedback! You're helping us improve.