Configuring an SVM
Configuring an SVM
July 22, 2024
ID 179765
Initial configuration of an SVM using configuration commands consists of the following steps:
- Modify the SVM name (the
hostname
command). - For each network interface of the SVM:
- Configure DNS settings if static IP addressing is used (the
dns
command). - Configure the settings for connecting the SVM to Kaspersky Security Center Administration Server: address and ports (the
nagent
command). - Initial configuration of the Protection Server (the
productinstall
command). - Accept the Kaspersky Security End User License Agreement and the Privacy Policy (the
accept_eula_and_privacypolicy
command or theaccept_eula_and_privacypolicy
setting in the ScanServer.conf configuration file).You must accept the terms of the End-User License Agreement and the Privacy Policy for the proper SVM operation.
- Start the Protection Server (the
manageservices start scanserver
command).
In addition, you can configure the following SVM configuration settings:
- Select the language of Kaspersky Security Center Network Agent Connector (the
connectorlang
command). - Change the configuration password and
root
account password that were defined by default (thepasswd klconfig
andpasswd root
commands). - Allow or deny access to the SVM over SSH under the
root
account.
After initial configuration of the SVM is completed, it is recommended to make sure that the SVM is deployed and configured successfully. To do so, you can use the checkconfig
command.
Did you find this article helpful?
What can we do better?
Thank you for your feedback! You're helping us improve.
Thank you for your feedback! You're helping us improve.