Enabling or disabling the VRRP protocol

You can enable or disable the VRRP protocol in a CPE template or on a CPE device. VRRP protocol enabled or disabled in the CPE template is automatically enabled or disabled on all CPE devices that use this CPE template.

To enable or disable the VRRP protocol:

1. Enable or disable the VRRP protocol in one of the following ways:
   • If you want to enable or disable the VRRP protocol in a CPE template, go to the SD-WAN → CPE templates menu section, click the CPE template, and select the VRRP → VRRP instances tab.
   • If you want to enable or disable the VRRP protocol on a CPE device, go to the SD-WAN → CPE menu section, click the CPE device, select the VRRP → VRRP instances tab, and select the Override check box.

   A table of VRPP instances is displayed.

2. In the VRRP drop-down list, select one of the following values:
   • Enabled
   • Disabled (default).

   When enabling VRRP, you must create at least one VRRP instance.

3. In the upper part of the settings area, click Save to save the settings of the CPE template or CPE device.

Page top