Working with SD-WAN instances

The table of SD-WAN instances is displayed in the SD-WAN → SD-WAN instances section. Information about SD-WAN instances is displayed in the following table columns:

• ID is the ID of the SD-WAN instance.
• Tenant is the tenant for which the SD-WAN instance is deployed.
• Status is the status of the SD-WAN instance:
  • Ok means the SD-WAN instance is operating normally.
  • Controller is absent means the SD-WAN instance does not have a controller.
  • Error means an error occurred during the operation of the SD-WAN instance.
  • Deleting means the SD-WAN instance is in the process of being deleted.
  • Deleted means the SD-WAN instance was deleted.
• # of CPEs is the number of CPE devices that have been added to the SD-WAN instance.
• Controllers are IP addresses and port numbers of controllers of the SD-WAN instance.
• DC is the data center in which SD-WAN instance is deployed.
• VIM is the VIM of the SD-WAN instance.
• Created is the date and time when the SD-WAN instance was deployed.

The actions that you can perform with the table are described in the Managing solution component tables instructions.

The SD-WAN instance settings are displayed on the following tabs:

• Configuration contains basic information about the SD-WAN instance.
• Monitoring contains SD-WAN instance monitoring results.
• Service requests contains service requests of the SD-WAN instance.
• Tenant self-service contains tenants that have been added to the SD-WAN instance.

In this section Configuring controller nodes of an SD-WAN instance Viewing the usage of an SD-WAN instance Viewing the topology of an SD-WAN instance Adding a tenant to an SD-WAN instance Removing a tenant from an SD-WAN instance Deleting an SD-WAN instance

Page top