Scheduling firmware updates on selected CPE devices

To create a scheduled firmware update task on selected CPE devices:

  1. In the menu, go to the SD-WAN → CPE section.

    A table of CPE devices is displayed.

  2. Proceed with the scheduled firmware update in one of the following ways:
    • If you want to perform a scheduled firmware update on an individual CPE device, click the CPE device and under Actions, click Update firmware.
    • If you want to perform a scheduled firmware update on multiple CPE devices, select the check boxes next to relevant CPE devices and in the upper part of the table, click Actions → Update firmware.

    Obsolete firmware is highlighted in orange in the SW version column of the table of CPE devices. You can also find CPE devices with outdated firmware versions using the Need update filter in the upper part of the table.

  3. This opens a window; in that window, in the Task name field, enter the name of the scheduled task.
  4. In the Version drop-down list, select the uploaded firmware. If you do not know which firmware version you need to install on the CPE device, use the table of correspondence of CPE device models with firmware versions.
  5. In the Scheduled task execution date field, enter the date and time when you want to run the task. By default, the date and time specified is the date and time when you started creating the task.
  6. If you want to reset the CPE device to factory settings after updating the firmware, clear the Save CPE settings check box. If the check box is selected, your existing CPE device settings are not modified after a firmware update. This check box is selected by default.

    When a CPE device is reset to factory settings, it is disconnected from the orchestrator. To reconnect the CPE device to the orchestrator, you need to automatically register (ZTP) the CPE device.

  7. The Force update check box lets you force the firmware update, even if the CPE's internal check shows that the new firmware is incompatible with the old one. This check box is cleared by default.
  8. Click Next.

    Two tables of CPE devices are displayed. Firmware of CPE devices in the upper table is updated. Firmware of CPE devices in the lower table is not updated. Information about CPE devices is displayed in the following columns of the table:

    • DPID is the DPID of the CPE device.
    • Model is the model of the CPE device.
    • Name is the name of the CPE device.
    • SW version is the firmware version of the CPE device.
    • Tenant is the tenant to which the CPE device has been added.
    • Reason is the reason why the firmware cannot be updated. This column is displayed only in the lower table.

    If the upper table contains CPE devices on which you do not want to update the firmware, you can move these CPE devices to the lower table.

  9. Click Schedule.

The firmware update task is created and displayed in the task table. The status of the tasks is displayed in the Status column. If the firmware update task finishes successfully, its status changes to Done.

Page top