Creating a UNI

You can create a UNI on an individual CPE device. Before creating an UNI, you must complete the following steps:

• Activate the CPE device.
• Create a QoS rule.

To create a UNI on a CPE device:

1. In the menu, go to the SD-WAN section.

   By default, the CPE subsection is displayed with a table of CPE devices.

2. Click the CPE device.

   The settings area is displayed in the lower part of the page. You can expand the settings area to fill the entire page by clicking the expand button .

3. Select the UNI tab.

   A table of UNIs is displayed.

4. Click + UNI.
5. This opens a window; in that window, in the Name field, enter the name of the UNI.
6. In the Port drop-down list, select the OpenFlow interface on top of which you want to create a UNI.
7. In the Encapsulation drop-down list, select the UNI encapsulation type:
   • Access (selected by default)
   • VLAN
   • Q-in-Q
8. If in the Encapsulation drop-down list, you selected VLAN, in the VLAN ID field, enter the outer VLAN tag. Range of values: 1 to 4094.
9. If in the Encapsulation drop-down list, you selected Q-in-Q, follow these steps:
   1. In the VLAN ID field, enter the outer VLAN tag. Range of values: 1 to 4094.
   2. In the Inner VLAN ID field, enter the inner VLAN tag. Range of values: 1 to 4094.
10. In the QoS drop-down list, select the previously created QoS rule for the UNI.
11. Click Create.

    The UNI is created and displayed in the table.

12. In the upper part of the settings area, click Save to save the configuration of the CPE device.