Viewing the topology of a deployed SD-WAN instance
Viewing the topology of a deployed SD-WAN instance
You can view the topology of a deployed SD-WAN instance. The topology displays tunnels and segments between CPE devices, as well as the paths within the segments.
To view the topology of a deployed SD-WAN instance:
- In the menu, go to the Infrastructure section.
This opens the resource management page. By default, the Network resources tab is selected, which displays the table of SD-WAN and SDN Controllers.
- Click Management → Configuration menu next to the Controller deployed for the SD-WAN instance.
This opens the Controller configuration menu. By default, you are taken to the Controller nodes section, which displays a table of Controller nodes.
- Go to the Topology section.
The topology of the SD-WAN instance is displayed.
- If necessary, select the following check boxes:
- Select the Tunnel utilization check box to display the utilization of the tunnels. The utilization level of the tunnel is represented by the following colors:
- Green — Low tunnel utilization.
- Yellow — Medium tunnel utilization.
- Red — High tunnel utilization.
- Select the Segments check box and in the Segment switches drop-down list, select two CPE devices to display all tunnels between those devices.
- Select the Name check box to display the names of CPE devices.
- Select the IP address check box to display the IP addresses of CPE devices.
By default, all check boxes are cleared.
- Select the Tunnel utilization check box to display the utilization of the tunnels. The utilization level of the tunnel is represented by the following colors:
Did you find this article helpful?
What can we do better?
Thank you for your feedback! You're helping us improve.
Thank you for your feedback! You're helping us improve.